ACC HDLC-NRM (SDLC) User's Guide

Software Installation and Verification
Software Removal
Chapter 2 21
Software Removal
CAUTION If a previous version of the HDLC-NRM (SDLC) protocol product is
already installed on the HP-UX system, it should first be removed. It is
very important to follow the instructions provided with the software that
is currently installed in the system to shutdown and remove that
software. This procedure may change between major releases of the
product.
Step 1. Log in to the system as superuser.
Step 2. Terminate the ACC Mux Subsystem by typing:
% zmasterd kill
Step 3. Run swremove to remove the HDLC-NRM (SDLC) protocol product.
% swremove
NOTE The swremove will fail if any ACC daemon is still active. Terminate any
active ACC daemon indicated in the log file and try again.
Any of the ACC related products can be removed by selecting them and
then marking them for removal. (Both the terminal interface and the
GUI interface for swremove behave the same; only the means for
selecting items differs.)
Step 4. Select the HDLC-NRM (SDLC) protocol product (and any other items to
be removed) in the “Software Selection Window” and mark for removal,
using the “Mark for Remove” function under the “Actions” menu. When
all items are marked, select the “Remove(analysis)” action.
Open “Logfile” to view running status of the removal process, and follow
any screen prompts until the removal process is done.