ACC HDLC-NRM (SDLC) User's Guide

Software Installation and Verification
Installation Verification
Chapter 2 27
Step 6. Use the zterm utility to enable and activate the HDLC-NRM (SDLC)
terminals:
% zterm
13:13:43 ZCOM Interactive command utility
13:13:43 Primary ZLU is 801
ZTERM> rc 1 20
ZTERM> cn 1 20 en
ZTERM> cn 1 20 ac
ZTERM> rx
13:14:03 Stat chg (UP) rspns from ZLU#00011(00123) No error detected
13:14:03 Stat chg (UP) rspns from ZLU#00001(00123) No error detected
13:14:03 Stat chg (UP) rspns from ZLU#00012(00123) No error detected
13:14:03 Stat chg (UP) rspns from ZLU#00002(00123) No error detected
<CNTRL-C>
13:14:06 Error on ZREAD: Interrupt occurs while waiting
13:14:06 Messages received 4, Messages sent 0
13:14:06 Elapsed time secs 3, Messages/sec 1
13:14:06 Data in KBytes 0, Data rate (KB/s) 0
13:14:06 Sys CPU 0%, User CPU 1%, Total CPU 1%
13:14:06 Mux 0 utilization 5%
ZTERM> ex
Step 7. You can now use the zmntr utility to observe the state of the link:
% zmntr
ZMNTR> tt 1 20
ZLU# Mx p:sc Terminal Description.... Rx.Mes Tx.Mes Error E.Rate State.
0001 00 0:00 HDLC/NRM Primary A 0 0 0 0.00% Up
0002 00 0:00 HDLC/NRM Primary B 0 0 0 0.00% Up
0011 00 1:00 HDLC/NRM Secondary A 0 0 0 0.00% Up
0012 00 1:00 HDLC/NRM Secondary B 0 0 0 0.00% Up
**** ** ** Message totals 0 0 0 0.00% *******
ZMNTR> ex