ACC Installation and Configuration Guide

Software Installation and Verification
Installation Verification
Chapter 242
Bringing Up ZCOM Mux Subsystem
Before any of the features of the ZCOM Mux Subsystem can be accessed,
it must be started up by running zmasterd (located in /opt/acc/bin) with
an appropriate .tmem file. The /opt/acc/cfg/loopback.tmem file should
be used, followed by performing the loopback verification test:
# zmasterd cold /opt/acc/cfg/loopback.tmem
Messages indicating whether or not the ZCOM Mux subsystem was
started successfully will be logged to the file
/var/opt/acc/log/XXX.tlog, where XXX represents the day of the week
(i.e. mon.tlog, tue.tlog, etc.).
The following listing is an example of what might be displayed when the
ZCOM Mux subsystem is started successfully. Note that in this example,
the /opt/acc/cfg/loopback.answ file is configured to start up two mux
cards.
------------------------------------------------------------------
Tue Jun 20 16:45:38 1998: zmlog: message logging resumed
------------------------------------------------------------------
16:45:37 zmast 00101 Launched daemon zmlog, pid 10663.
16:45:37 zmast 00117 Zmasterd daemon start running...
16:45:37 zmast 00101 Launched daemon zmon, pid 10665.
16:45:38 zmon 00002 Resource manager (Rev 1.32) for ZCOM 6.2.0.0
16:45:38 zmon 00003 Cold start with: /opt/acc/cfg/loopback.tmem
16:45:39 zmon 00100 Card 0 starting up ...
16:45:39 zmon 00100 Card 1 starting up ...
16:45:46 zmon 00110 Card 0 startup successful, card READY
16:45:46 zmon 00110 Card 1 startup successful, card READY
16:45:46 zmon 00020 Cold start completed, ZCOM system ready
16:45:46 zmon 00004 Waiting for ZMON requests ...
16:45:46 zmast 00101 Launched daemon znode, pid 10674.
16:45:57 zcom 00165 Node 123 is now UP