ACC Programmer's Reference Guide

80 Chapter3
ZCOM Tables and Data Structures
Interface Table
IRSERR - Restart error count
This field contains the count of the number of errors which occurred
during the last restart or enable. These errors are due to $PORT or
$TERM commands and will be separately reported to ZMON. This field
is kept for information purposes only.
IFSTCN - Status update request count
This counts the number of $STDT replies until IFRTRY will be
decremented.
INTFNO - Interface card number
This is the interface number that was specified in the Mux statement of
the TTGEN configuration file.
IMAXPORTS - Maximum number o f ports on card.
This field contains the maximum number of ports supported by this
specific ACC interface card.
IMAXSUBC_PORT - Maximum number of subchannels per port.
This is the maximum number of subchannels supported on each port of
this ACC interface card. The minimum value of this field is 1 (e.g.
2/8-channel cards).
IMAXSUBC_CARD - Maximum numb er o f subchannels on card.
This field contains the number of subchannels supported by this card.
For a non-E1/T1 card, t his val ue should be the same as the imaxports
field.
IMAXTERMS - Maximum number of terminals allowed on card.
This field contains the maximum number of terminal ZLUs that may be
configured on this card.
IFNAME - Firmware download file name
This contains the full path name of the firmware file to be downloaded
into this Mux card whenever the ZCOM subsystem is started, the Mux
card is reset, or is recovering from a powerfail or firmware failure. It is
initialized from the information supplied in the Mux statement of the
TTGEN configuration file. This field is a maximum of 256 bytes
including the null terminator byte.