ACC Utilities Reference Guide

ZTERM - Interactive Routine Interface
ZTERM Available Commands
Chapter 4104
Functions in the same way as the SE command but in this case the zcntl
routine is used to generate a control write request, rather than zsend
(which generates a write request). ZTERM responds with:
Input message (max 80 chars)
Enter text for the control write, then press <return>.
DI - Control Displays
Format: DI,on/off/error
Controls the display of messages by commands that send or receive
messages (e.g., RE - read, RX - receive, RL - receive and loopback, TX -
transmit). If the display is set off, then all the messages are suppressed.
If error is used then only messages containing non-zero status codes are
displayed. If on is used, the full message display is restored.