ACC Utilities Reference Guide

ZTERM - Interactive Routine Interface
ZTERM Available Commands
Chapter 4120
done with buffers shorter than 10 bytes. The latency
statistics are displayed when the RL command
terminates or is terminated.
sendmode The mode as explained under zsend in the ZCOM
routine calls section of the ACC Programmer’s
Reference Guide. Each received message is resent with
this mode.
dzlu The ZLU to which the message is to be routed (default
to source if not specified).
AC Activate the terminal ZLU after every received
message (restart polling).
maxtime This parametersets a maximum runtime, in seconds. If
this is zero then the command runs without a time
limit, otherwise it will terminate after [maxtime]
seconds.
The display of the message information is controlled by the DI (display)
command.
This is a blocking command and will remain active until a ZCOM call
error is encountered (such as ZCOM shutdown, ierr=-2), or until a sigint
(usually ^C) is received by ZTERM. It accumulates the number of
messages received for the duration of the command and the elapsed time
in milliseconds. This information is displayed when the command is
stopped or completes.