ACC Utilities Reference Guide

ZTERM - Interactive Routine Interface
ZTERM Available Commands
Chapter 4126
tagp Terminal tag parameter (mrqtag)
maxtime Optional maximum runtime
apno If set this must match the ltapno field in the logical
terminal table of the terminal ZLU, otherwise no
messages will be sent on that ZLU.
If the command is issued as TVFL rather than TV then a flag message is
sent 1 second before the first data message, and on completion of the test
a termination message is sent to every terminal ZLU which has been
used in the test. The completion message contains the number of
messages sent to that ZLU. These message are used by the receiving copy
of ZTERM to delimit the start and end of the test and to verify that all
messages have been received. The receiver resets it’s statistics when the
start message arrives and terminates the RV command when the end
message arrives.
The command optionally has a maximum runtime set in the [maxtime]
parameter. If this is zero then the command runs without a time limit,
otherwise it will terminate after [maxtime] seconds.
If the [apno] field is used then only terminal ZLUs whose logical terminal
table application number “ltapno” field matches the [apno] field are used.
If [apno] is not set then all terminals in the range are used.
TX - Transmit Test
Format:- TX,ZLU,[len],[mode],[total],[window],[tagp],[apno]
The TX command is used for a general transmit test. The parameters
have the following meanings:
ZLU ZLU to which messages are to be sent
len Length of the test messages [0..8000], default is 40
mode Any valid send mode (see under ZSEND),
default 0 - Send no wait, no errors
total Total number of messages, default 1
window Only applicable if definite status requested.
Indicates the number of messages that will be sent
before any acknowledgments are waited on
tagp Terminal tag parameter (mrqtag)