ACC Utilities Reference Guide

ZNODE - Remote Node Daemon
Demonstrating Remote Node Functionality
Chapter 8 183
Demonstrating Remote Node Functionality
To demonstrate that the remote nodes are correctly configured and are
communicating with the local node, an example is shown below. The
entries typed are shown in bold type and the sequence is indicated by a
number to the left of each entry. Note that the entries are typed in
sequence at both nodes A and B.
Node A (Number 10)
# zterm
11:19:48 ZCOM Interactive command utility
11:19:48 Primary ZLU is 1001
1 ZTERM> nd 20
11:19:55 Destination node is 20
2 ZTERM> tx 3001 1024 0 10
11:20:03 TX test complete!!!
4 ZTERM> rx
11:20:06 Msg from prog ZLU#03001(00020) len 1024 tag=00001,00000
11:20:06 Msg from prog ZLU#03001(00020) len 1024 tag=00002,00000
11:20:06 Msg from prog ZLU#03001(00020) len 1024 tag=00003,00000
11:20:06 Msg from prog ZLU#03001(00020) len 1024 tag=00004,00000
11:20:06 Msg from prog ZLU#03001(00020) len 1024 tag=00005,00000
11:20:06 Msg from prog ZLU#03001(00020) len 1024 tag=00006,00000
11:20:06 Msg from prog ZLU#03001(00020) len 1024 tag=00007,00000
11:20:06 Msg from prog ZLU#03001(00020) len 1024 tag=00008,00000
11:20:06 Msg from prog ZLU#03001(00020) len 1024 tag=00009,00000
11:20:06 Msg from prog ZLU#03001(00020) len 1024 tag=00010,00000
5 ^C
11:20:14 Error on ZREAD: Interrupt occurs while waiting
11:20:14 Messages received 10, Messages sent 0
11:20:14 Elapsed time secs 52, Messages/sec 0
11:20:14 Data in KBytes 10, Data rate (KB/s) 0
11:20:14 Sys CPU 0%, User CPU 0%, Total CPU 0%
11:20:14 Mux 0 utilization 1%8 ZTERM> ex
#