ACC Utilities Reference Guide

ZDGEN - ZCOM Device Table Generator

Device Definition File Example

Chapter 120

Device Definition File Example

NOTE The information in this example may be out of date and should NOT be

used when configuring a ZCOM subsystem. Refer to the current Device

Definition file supplied (/opt/acc/cfg/zcomdevice.txt).

;==========================================================================+

; ;

; ZCOM device type description Rev.01.C <960325.1621> ;

; ;

;==========================================================================+

; ;

; There are 10 parameters for each device description. Each line can ;

; only define one device. Lines begin with ‘;’ or ‘*’ are treated as ;

; comments. Blank lines are also ignored. ;

; ;

; Device parameters: ;

; ;

; Type: Device type (sequential from 1,2,3,...) ;

; Name: 16 char max, capital, no leading or embedded spaces or comma ;

; Prot: Physical protocol type (0..63) ;

; Sc: Logical screen type (1..31, see MFORM) ;

; A: Number of bytes of Poll/Select addresses (0,1,2) ;

; Min: Lower bound of P/S address (0..255) ;

; Max: Upper bound of P/S address (0..255) ;

; Opt: Protocol options (bits 0 to 15 only) ;

; LOGFG: LTFLAG word for logical terminal table ;

; Module: Protocol module name ;

; ;

;==========================================================================+

; ;

; Device types 1 to 32 are for private use. Any specific or test device ;

; types may be defined in this range. ;

; ;

;==========================================================================+

* Type Name............Prot Sc A Min Max Opt LOGFG Module Refer-To

01, , 00 00 0 00H 00H 000H 0000H