ACC Utilities Reference Guide

ZMNTR - ZCOM Runtime Monitor
Command Modifiers
Chapter 3 73
Command Modifiers
A number of the commands have selection modifiers to restrict their
action to only those that meet certain criteria.
The commands are immediately followed by one or more of the following
modifiers:
V X.25 Virtual circuits
L X.25 Link circuits
N X.25 Link terminal configuration
X X.25 Link statistics (not with the DC command)
O Multiplexed terminals (using the ZCOM inbound and
outbound multiplexing)
M Show ALL multiplexed terminals in a group
P Show ALL terminals on a port
A Show unavailable terminals as well (i.e. those
configured on an absent card)
These modifiers are specified as character additions to the original
command. The order that they are used is not important. For example:
TTL,nn,mm is used to display all the link circuits in the range specified.
The commands for which these modifiers are available are:
TT Terminal Status
DC Terminal configuration
For example:
ttv,1,100 Will display all X.25 virtual circuits connected to
terminals in the range 1 to 100.
div,1,100 Will disable all X.25 virtual circuits connected to
terminals in the range 1 to 100.
dco,1,100 Will display the configuration for the multiplexed
terminals only (not the virtual circuits or links) in the
range 1 to 100.
tdlv,1,100 Will display all X.25 links and virtual circuits whose
terminals are down.