ACC Utilities Reference Guide

ZMNTR - ZCOM Runtime Monitor
Commands
Chapter 378
! - Execute a shell command
Format: !shell_command_string
Temporarily suspend “zmntr” and execute a shell command.
/E - Exit from ZMNTR
Format: /E
The /E command is used to exit ZMNTR. It is also possible to use EX,
which has exactly the same effect.
DC - Display Configuration (Terminals)
Format: DC,mm,nn,[name]
This command displays the configuration information of the terminals in
the ZLU range mm to nn. The [name] parameter is optional. If specified,
then only terminals whose descriptions contain the string are shown.
Note that these commands can use the command modifiers L, V, and O.
See the MOD help (?? mod).
Example:
ZMNTR> dc 10 310
Zlu# Mx p:sc Tmnl.type...... Configuration............................
0010 00 0L01 X25.LAPB DTE T1=0.400s #226633011 X25 DTE POS 226633004
0100 00 0V01 X25.SVC.IN VC=0000 #=226633011 X.25 SVC in from 33011
0020 00 1L01 X25.LAPB DCE T1=0.400s #226633011 X25 DCE POS 226633004
0200 00 1V01 X25.SVC.AUTO VC=0000 #=226633011 X.25 SVC out to 33011
0030 00 0L02 X25.LAPB DTE T1=2.200s #No address L2 DTE
0300 00 0V02 X25.SVC.IN VC=0001 #=No address L3 svc
0301 00 0V02 X25.SVC.IN VC=0002 #=No address L3 svc
It is also possible to specify the name of the terminal, which appears
under “configuration”. If the name is specified, then only those terminals
with that name string are displayed. For example:
ZMNTR> dc 10 310 DCE
Zlu# Mx p:sc Tmnl.type...... Configuration............................
0020 00 1L01 X25.LAPB DCE T1=0.400s #226633011 X25DCE POS 226633004
The following is an example using an X.25 modifier.