ACC Utilities Reference Guide

ZMNTR - ZCOM Runtime Monitor
Commands
Chapter 3 89
RC - Reset Rx, Tx and Error Counters
Format: RC,nn,[mm]
This command resets the counters of terminals in the range nn to mm. If
only nn is entered, then the request is performed for only the one
terminal. After the request has been made, the system asks for
confirmation:
Reset counters for ZLUs nn to mm, ok? -
Answer YES to reset the counters or NO to abort the command.
The RCX command resets the Level 2 X.25 statistical counters for all
X.25 Link terminals defined in the specified range nn to mm.
SET - Set or display ZMNTR settings
Format:- SET [parameter] [value]
This command sets some internal parameters of ZMNTR. Currently
allowed parameters are:
Parameter Value
node Remote node number (0..65535)
If “parameter” is specified without a “value”, the settings of that
parameter is displayed. If no parameter/value is specified, the setting of
all internal parameters are displayed.
Parameter “node”
Setting a remote node causes subsequent ZMNTR commands to be
issued to that node instead of the local system, hence allowing ZMNTR to
monitor a remote ZCOM system. A 'value' of 0 means the local system. If
'value' is not specified, the current remote node is shown. Make sure
'znode' is running before using a remote node.
WARNING Issuing ZMNTR commands to a remote node can incur heavy
network traffic.