ACC Utilities Reference Guide

ZMNTR - ZCOM Runtime Monitor
Commands
Chapter 3 95
Terminal descriptions for the virtual circuits are:
SVC - switched virtual circuit (two-way)
SVCO - switched virtual circuit (outgoing)
SVCI - switched virtual circuit (incoming)
PVC - permanent virtual circuit
Each of these may be followed by “=n/c” if the call is not connected, or by
a logical channel number if the call is connected. To the right of this
information, there is the X.121 address. For SVCO, it is the address of
the remote DTE to which a call will be made, while for SVCI, it is the
address of the remote DTE from which a call will be accepted (calls from
other DTEs will not be accepted). If no X.121 address is specified for an
SVCI, then a call will be accepted from any X.121 address.
The “PT” command gives the same information as “TT” but for the
terminals on a specific port, rather than for a range of terminals.