ACC X.25 Data Analyzer User's Guide

Installing the Data Analyzer
Installing the Analyzer Software
Chapter 218
Installing the Analyzer Software
The data analyzer software is provided with the ACC Base Product,
which comes in SD-UX format.
Installation requires the following general steps:
1. Remove any previous version of the data analyzer software with
swremove.
2. Use swinstall to install the ACC base product (or just the data
analyzer software if ACC base software is already installed).
3. Check /var/adm/sw/swagent.log for any errors during install.
4. Configure the analyzer.
Software Removal
If a previous version of the ACC X.25 Protocol Analyzer product is
already on the target system, remove it before the new software is
installed.
CAUTION It is very important to follow the instructions, provided with the ACC
software that is currently installed in the system, to shut down and
remove that software. This procedure may change between major
releases of the ACC product.
Step 1. Log in to the system as superuser.
Step 2. Terminate the ACC Mux Subsystem by typing:
% zmasterd kill
Step 3. Run swremove to remove the ACC X.25 Protocol Analyzer product.
% swremove