ACC X.25 Data Analyzer User's Guide

Data Analyzer Commands
options
Chapter 3 33
z/Z Turn off/ON Level 4 raw display (s/S option gives raw
mode).
To change the option setting use the
set parameter followed by one or
more of the letters in the table above; for example, the command below
turns off the event and timestamp display, enables the Level 4 raw data
display, and turns on the Modem control lead change display.
Display> options set eZL
To show the current option setting, use just the options command by
itself or use the
show parameter. Note that the options display includes a
summary of the letters required to modify the setting beside each of the
state indications. For example, in the line “Level 2 header decode: Yes
u/U,” the letters u/U are used to turn OFF or ON the Level 2 header
decoding.
Example
To set the display options back to their original state use the default
parameter:
Display> options default
Default display options set
Level 2 Decode header: Yes u/U
Display raw data: No v/V
Level 3 Decode header: Yes w/W
Decode facilities: Yes x/X
Display raw data No y/Y
Display Event# & time (e/E) No
Display Lead changes (l/L) Yes
Raw data display (see below) ASCII8
Raw data single or full (s/S) Single
Reverse Sense DTE/DCE (r/R) DCE
Current option settings
Display> options show