ACC X.25 Data Analyzer User's Guide

Data Analyzer Commands
show
Chapter 338
show
This command displays all the ZLUs configured in the ACC Mux system.
Format
show
Description
The show command shows the mode, state, and file information for each
ZLU. For example:
Display> show
ZLU.# MX P Sub Typ AZLU# Mode Stat LC.M size Filename................
19 02 2 000 DTE 20 Halt Stop None 508 /var/opt/acc/log/anz_19.eve
20 02 3 000 DCE 19 Halt Stop None 508 /var/opt/acc/log/anz_19.eve
21 02 4 000 DTE 22 Halt Run None 256 /var/opt/acc/log/anz_21.eve
22 02 5 000 DCE 21 Halt Run None 256 /var/opt/acc/log/anz_21.eve
23 02 6 000 DTE 24 Halt Stop None 0
24 02 7 000 DCE 23 Halt Stop None 0
The columns in the example above are explained below:
ZLU.# This is the ZLU number of a port assigned to the Data
Analyzer. These ZLUs are recognized by the
application number being set to 90 in the network
configuration file.
MX P This shows the mux number and port number within
the mux that the ZLU # is connected to.
Sub This shows the sub-channel number within the mux
and port number that the ZLU # is connected to.
Typ The Port must be either a DTE or DCE. This identity is
setup in the network configuration file. If the port is
configured as a DTE then the Y-cable port labeled TX
monitor should be connected to it, if it is a DCE port
then the RX monitor cable should be connected to it.
See the configuration section for more details.