ACC X.25 Data Analyzer User's Guide

Data Analyzer Commands
stopd
Chapter 342
stopd
The stopd command stops the analyzer and deletes the analyzer ZLUs
in use provided that they were dynamically configured by previous use of
the runc command.
Format
stopd card port [subchannel]
Description
This command stops the protocol analyzer on the specified card, port and
(if an applicable card type is in use) subchannel.
pdisplay then deletes the corresponding pair of analyzer ZLUs.
This command cannot be used to delete analyzer ZLUs statically
configured in the network (ttgen) configuration file.
NOTE Be sure that you intend to DELETE the ZLU pair on the specified
mux/port/subchannel. If you only intend to halt the analyzer, use the
stop command.