ACC X.25 Data Analyzer User's Guide

Network Configuration
Setting Up the Network Configuration File
Appendix A44
Setting Up the Network Configuration File
The first step is to configure the analyzer ports into the ttgen
configuration file. A sample file is supplied with the product to illustrate
how the configuration should be done. This file is called
/opt/acc/cfg/x25an_sample.answ, or x25an_4ch_sample.answ. A full
listing of these files is given at the end of this appendix. Some parts of
these files are used below to illustrate the configuration process.
NOTE If the sample file is to be used as a test of the product, ensure that the
multiplexer bus and slot numbers are changed in the file so that they
correspond to the actual position of the multiplexer card.
Mux Firmware Download File
The Frame capture protocol used by the X.25 Protocol Analyzer is
provided in all the downloadable files. The X.25 Protocol Analyzer may
be used with any of these files.
The mux firmware download file is specified in the network
configuration file in the card-type statement. For example:
z7340a 0 0:4 /opt/acc/z7340a/x25.zabs
Each multiplexer that is to run X.25 connections, or Data Analyzer ports,
will need a card-type entry, such as z7340a. The bus and slot numbers
must correspond to the physical position of the interface card. Refer to
the ACC Installation and Configuration Guide for more information on
determining the hardware location.