ACC X.25 Data Analyzer User's Guide

Typical X.25 and Data Analyzer Sessions
Introduction
Appendix B54
Introduction
This section provides the results of actual Data Analyzer sessions that
were run using this software. The sessions were run on an 8-Channel
multiplexer.
Because the 8-Channel multiplexer was not designed to provide ISDN
service, only an X.25 session is described for this product.
General Procedures
The process involved with all sessions described in this appendix is
generally as follows:
• Ensure that the ACC multiplexer hardware and its base system and
X.25 software are properly installed (per supplied manuals );
• Ensure that the X.25/ACC configuration has been properly set up:
refer to the X.25/ACC Installation and Configuration Guide as
needed;
• Start up the ZCOM muliplexer subsystem (described below);
• Establish an X.25 connection via the ACC Multiplexer (described
below);
• Send packets over the connection using the X25Check utility
(described below);
•Run Data Analyzer’s pdisplay program to observe trace of the
captured file.
These sessions were run with the HP-UX utility Script executing in the
background, to preserve a trace of all terminal activity involved with the
procedures.