ACC X.25 Protocol User's Guide

Installation
Installation Verification
Chapter 2 21
----------------------------------------------------------------------
Tue Mar 1 09:48:51 2000: zmlog: message logging resumed
----------------------------------------------------------------------
09:48:52 zmon 00002 Resource manager (Rev 1.32) for ZCOM 6.2.0.0
09:48:52 zmon 00003 Cold start with: /opt/acc/cfg/x25_sample.tmem
09:48:52 zmon 00100 Card 0 starting up ...
09:49:00 zmon 00110 Card 0 startup successful, card READY
09:49:00 zmon 00020 Cold start completed, ZCOM system ready
09:49:00 zmon 00004 Waiting for ZMON requests ...
09:49:00 zmast 00101 Launched daemon zx25d_init, pid 862.
09:49:01 zx25d 00643 X25 Protocol server started - Rev: 3.10 - 991201
Logical terminal area X25CNT: 88 Bytes
09:49:19 zcom 00162 3 ZNODE inactive for 20 seconds, all nodes DOWN
Note that the last log message regarding the znode program will be
displayed in the case that the znode program is not in use. Refer to the
ACC Installation and Configuration Guide for more information on
znode.
Step 5. If zmasterd was configured not to initialize the ACC X.25 subsystem,
then run zx25d_init manually to initialize the zx25d driver:
% zx25d_init
The following zmlog messages should be seen on the console or in the
zmlog log file:
09:50:10 zx25d 00643 X.25 Protocol server started - Rev: 3.10 - 991201
Logical terminal area X25CNT: 88 Bytes
09:50:11 zx25d 00621 Link ZLU 10 HDLC/LAP-B established on enable.
09:50:11 zx25d 00621 Link ZLU 20 HDLC/LAP-B established on enable.
09:50:12 zx25d 00642 Link ZLU 20 X.25 Packet layer (lvl 3) restart complete.
09:50:12 zx25d 00642 Link ZLU 10 X.25 Packet layer (lvl 3) restart complete.