ACC X.25 Protocol User's Guide

Installation
Installation Verification
Chapter 222
The zmntr utility can be used at this point to show that Level 2
connections have been established:
% zmntr
ZMNTR> tt,1,200
ZLU# Mx Pt Terminal Description....Rx.Mes Tx.Mes Error E.Rate State.......
0010 00 0L X25DTE POS 226633004 1 6 0 0.00% Up,Link Estbd
0100 00 0V SVCI =n/c 226633011 0 0 0 0.00% Sd,No Call
0020 00 1L X25DCE POS 226633004 1 6 0 0.00% Up,Link Estbd
0200 00 1V SVCO =n/c 226633011 0 0 0 0.00% Sd,No Call
**** ** ** Message totals 2 12 0 0.00% ************
ZMNTR> ex
Step 6. At this point, the zterm utility can be used to bring up a virtual circuit
and transmit data:
% zterm
09:54:36 ZCOM Interactive command utility
09:54:36 Primary ZLU is 803
ZTERM> rc,100,200
[Set zterm to be receiver for messages to ZLUs 100 to 200.]
ZTERM> cn,100,200,en [Issue an ”enable” control request to ZLUs 100 to 200.]
ZTERM> cn,100,200,ac [Issue an ”activate” control request.]
ZTERM> rx
10:33:35 Stat chg (DN) rspns from ZLU#00100(00123) L.C. terminal ENABLED
10:33:35 Stat chg (DN) rspns from ZLU#00200(00123) L.C. terminal ENABLED
10:33:35 Stat chg (UP) rspns from ZLU#00100(00123) L.C. terminal set UP
10:33:35 Stat chg (UP) rspns from ZLU#00200(00123) L.C. terminal set UP
<CNTRL-C>
10:33:37 Error on ZREAD: Interrupt occurs while waiting
10:33:37 Messages received 4, Messages looped back 0
10:33:37 Elapsed time is 1574 ms
ZTERM> ex