ACC X.25 Protocol User's Guide

Installation
Using the X.25 Protocol Module
Chapter 2 25
Using the X.25 Protocol Module
The Multi-protocol ACC Installation and Configuration Guide contains
the general procedure for creating downloadable firmware files, creating
the ttgen configuration file, starting up the ACC subsystem with the new
protocol and new configuration. The X.25 specific requirements are noted
below:
•Include the zx25.zrel protocol module when creating the .zabs
firmware file (non-PCI bus only).
• Refer to the section “Configuration” on page 29 in Chapter 3, ZX25D
X.25 Protocol Driver, for X.25 specific configuration requirements
when building the ttgen configuration file.
•The program zx25d_init must be scheduled in order to use the X.25
protocol. The installation procedure will configure the zmasterd_list
file to automatically schedule this program when zmasterd is used to
start up the ZCOM subsystem.