ACC X.25 Protocol User's Guide

ZX25D X.25 Protocol Driver
Special ZMNTR X.25 Facilities
Chapter 362
Special ZMNTR X.25 Facilities
Refer to the separate ZMNTR (ZCOM monitor) documentation within
the ACC Utilities Reference Guide for further information on the
commands described below.
Information on how the commands can be used for X.25 may be obtained
from within ZMNTR by entering:
??,MOD
ZMNTR has been enhanced to include facilities for the display of
information specific to X.25. These facilities may be explicitly accessed by
use of command modifiers. The modifiers are:
O - only terminals (including X.25 terminals)
V - Virtual circuits
L - Link terminals
X - Link terminal statistical counters (TT only)
These modifiers are specified as character additions to the original
command. The order in which the modifiers are used is not important.
For example: TTL,nn,mm is used to display all the X.25 links in the
range specified. The commands for which these modifiers are available
are:
SD,SU,RE,FL- shutdown, startup, reissue, flush
TT- terminal table
DC- display configuration
PT- port table
For example:
TTV,1,100display all virtual circuits connected to
terminals in the range 1 to 100
SDV,1,100shutdown all virtual circuits connected to
terminals in the range 1 to 100
DCO,1,100display the configuration for the terminals
only (not the virtual circuits or links) in
the range 1 to 100.
TTLV,1,100display all links and virtual circuits
for configured terminals
For further information on these commands refer to the separate
ZMNTR (ZCOM monitor) documentation within the ACC Utilities
Reference Guide.