ACC X.25/ISDN Data Analyzer User's Guide

24 Chapter2
Installing the Data Analyzer
Installing the Analyzer Software
The “Install (analysis)” window allows you to track summary progress of
theinstallationprocess.Usethe“Logfile”featuretodisplayadetailed
status, which is l ogged to /var/adm/sw/swagent.log.
Verifying Installation
Check the end of the swinstall log file /var/adm/sw/swagent.log to
ensure that there were no errors during the installation. If errors
occurred, correct the problem and repeat the swremove and swinstall
steps.
The Data Analyzer software contains a sample capture file. This file is
installedinto the directory /var/opt/acc/log and is called sample.eve.
This file can be viewed using the pdisplay program. To try this, run
pdisplay from the shell prompt.
If neither the ZCOM subsystem nor the pcapture program a re currently
up and running, the following message will be displayed:
$ pdisplay
Bad zinit call, error:ZCOM system is not started up
Bad zopen call, error:Must call ZINIT first
Bad zopen call, error:Must call ZINIT first
Bad zname call, error:Must call ZINIT first
***** Warning *****
Cannot find primary ZLU of pcapture - pcapture probably not running
Some functions of this program will not be available
***** Warning *****
Cannot get storage offset for label ANLYZR,Error:Must call ZINIT first
Display>
If the ZCOM subsystem is up and running but the pcapture daemon is
not running, the following message will be displayed:
$ pdisplay
***** Warning *****
Cannot find primary ZLU of pcapture - pcapture probably not running
Some functions of this program will not be available
***** Warning *****
Display>