ACC X.25/ISDN Data Analyzer User's Guide

28 Chapter2
Installing the Data Analyzer
Configuring the Analyzer
For example, you can set-up and run the analyzer on the first two ports
of the first 8-Channel multiplexer card in the ACC subsystem by
entering the runc command as follows:
Display> runc 0 0
All of the options that are applicable to the run command also apply to
the runc command. See the entry for the runc command on page 41.
NOTE For the 4-port cards and Z7340A 8-port PCI card, all channels can b e
monitored. For 8-port EISA and HP-PB cards, the ports used for data
capture may NOT be used for active X.25 connections.