ACC X.25/ISDN Data Analyzer User's Guide

Chapter 3 39
Data Analyzer Commands
run
run
The run command starts the analyzer on a specified pair of ZLUs.
Format
run ZLU [-n filename] [-s filesize] [-l lcn#1 ..] -o {opts] -f
Description
The run command starts the analyzer running on a specified ZLU. It will
automatically fin d the asso ciated partner ZLU so that the correct DCE
and DTE ZLUs are started together.
-n Specify the capture file. If not given it will be defaulted
to /var/opt/acc/log/anz_ZLU.eve where ZLU is the
number specified in the command.
-s Specify the maximum size of the capture file. If not
given, a default size of 1Mbyte will be used. Once this
file size is reached, the capture halts.
-o Set the display options (refer to the options command
for details of option setting). Note the option settings
modified in this command will change the default
options for the next display command. These options
only have an immediate effect if the follow option is
used.
-f Set follow mode. In this mode the capture is started
and then the program goes into display mode,
displaying the data as it is stored into the capture file.
The display mode uses the previously defined options
plus any modifications in a -o option within this
command.
-l Specify LCN masking for events to be stored into the
capture file. If no LCN masking is given then all X.25
L2 and L3 traffic is stored into the file. If masking is
specified then only L3 traffic with matching LCN
numbers is stored. A maximum of 6 LCN numbers may
be specified.