ACC X.25/ISDN Data Analyzer User's Guide

Chapter 3 43
Data Analyzer Commands
show
AZLU This is the partner ZLU, which should also appear in
the display. The partner ZLU must be a different type
(DCE if this ZLU is a DTE, and DTE if DCE).
Mode The mode field gives the action that pcapture takes
when the capture file is full. It may be
Halt or Wrap .If
Halt is indicated then the analyzer will halt when the
file is full; if
Wrap is indicated then the file will be
overwritten with new data.
Stat This is the current state of the analyzer which may be
either
run or stop.
LC.M This shows that the LCN numbers are being used for
preprocessing filtering. Refer to the “run” command for
more details. If no LCN filters are set then this field
displays
none and all traffic is captured to the file,
otherwise
Yes is displayed and only the traffic for LCN
numbers specified in the run command are saved into
the file.
Size This is the current maximum file siz e in bytes.
Name This is the name of the capture file specified in the run
command or the default file name if no file was
specified. The default file name is of the form
/var/opt/acc/log/anz_ZLU.eve, where ZLU is the
ZLU number used in the run command.