ACC X.25/ISDN Data Analyzer User's Guide

56 AppendixB
Network Configuration
Setting Up the Network Configuration File
SettingUptheNetworkConfigurationFile
The first step is to configure the analyzer ports into the ttgen
configuration file. A sample file is supplied with the product to illustrate
how the configuration should be done. This file is called
/opt/acc/cfg/x25an_sample.answ,orx25an_4ch_sample.answ for
E1/T1 cards. A full listing of these files is given at the end of this
appendix. Some parts of these files are used below to illustrate the
configuration process.
NOTE Ifthesamplefileistobeusedasatestoftheproduct,ensurethatthe
multiplexer bus and slot numbers are changed in the file so that they
correspond to the actual position of the multiplexer card.
Mux Firmware Download File
The Frame capture protocol used by the X.25 Protocol Analyzer is
provided in all the downloadable files. The X.25 Protocol Analyzer may
be used with any of these files.
The mux firmware download file is specified in the network
configuration file in the card-type statement. For example:
z7200a 0 0:4 /opt/acc/z7200a/x25.zabs
Each multiplexer that is t o run X.25 connections, or Data Analyzer ports,
will need a card-type entry, such as z7200a. The bus and slot numbers
must correspond to the physical position of the interface card. Refer to
the ACC Inst allation and Configuration Guide for more information on
determining the hardware location.