Ethernet SNMP Module Installation and Reference Guide ( J2603B) 1995-10

See the HP Stack Manager online help and HP AdvanceStack 10Base-T
Hubs Installation and Reference Guide for more information.
Network Test
The Network Test window enables you to perform Ping, IPX, and Link
network tests. These tests are used to verify the connection between the hub
and a specified network device. The devices tested must support the test(s)
by being able to send appropriate response packets.
The Ping test sends Internet Control Message Protocol (ICMP) Echo Request
(“ping”) packets to another node with the specified IP address and waits for
Echo Response packets in return.
The IPX test sends IPX test packets to the specified IPX device and waits for
an IPX test packet in return.
The Link test sends IEEE 802.2 Test command packets and waits for an
IEEE 802.2 Test response packet in return.
Modem Configuration
Use the Modem Configuration window if you are running HP Stack Manager
from a PC that is connected to the hub’s RS-232 port via a modem link. This
window lets you define modem communications settings for both the
remote modem that you attach to the hub and the local modem that you
keep connected to your PC.
Factory Default Reset
When you install an HP Ethernet SNMP Module in your hub, the Reset
function in HP Stack Manager offers an additional reset option, Factory
Reset. Use this reset option to return the hub and the HP Ethernet SNMP
Module to the original factory configuration. All configuration except the IP
configuration is returned to the factory values.
Extended Hub
Capabilities
Extended Hub Capabilities
2-4