Ethernet SNMP Module Installation and Reference Guide ( J2603B) 1995-10

HUbselect <hub_number>
To access an attached chained hub. If no hub number is specified, the
hub directly connected to the console is selected.
The number is from the Entry column displayed when you use the CHainlist
command. First enter the command CH to list the chain.
Example: CH (This displays the following example table.)
Entry Model Station Address Description IP Address
___ _________________________________________________________
1* HPJ2601A AdvanceStack Et 080009-64cecf chain access pt
— HPJ2410A 100VG Hub-15 080009-5d8c04 ———none———-No SNMP module
— HPJ2410A 100VG Hub-15 80009-2b0682 ———none———-No IP address
4 HPJ2600A 10Base-T Hub-12 080009-6756d4 Tech Mkt. Hub-12,No SNMP module
— HPJ2601A 10Base-T Hub-24 080009-973eef Tech Mkt. Hub-24,192.1.1.1.10
6 HPJ2610A 10Base-T Hub-8 080009-1e61c4 Tech Mktg hubNo SNMP module
— HPJ2602A 10Base-T Hub-48 080009-975e35 Tech Mkt. Hub-48,No IP address
___ ___________________________________________________________ ____________
* Indicates hub that is currently selected
HU 3 (This accesses the hub with Entry number 3.)
Now accessing hub with station address: 080009-6756d4
An Entry number is displayed only for other HP AdvanceStack 10Base-T
hubs that do not have an HP Ethernet SNMP Module installed. Only hubs
with Entry numbers can be accessed from the current console session. For
more information about accessing hubs, see the CHainlist command.
Once you have connected to another hub, you can use the following
commands on that hub only:
CHainlist POrt
COunters [A|B..] REset
DIsconnect STatus
HUbselect THinwatch
Note that the DIsconnect command is not hub specific and will end your
console session.
Extended Hub
Capabilities
Extended Hub Capabilities
2-14