Ethernet SNMP Module Installation and Reference Guide ( J2603B) 1995-10

MAnagers [SHow]
To configure the list of network management stations that are
authorized to access and manage this hub, and to specify which of
those stations should receive alarms. Use the SHow option to display the
current list of authorized management stations without being prompted to
edit the list.
The list consists of the IP or IPX address of the network management station
and an indication of whether each management station should receive
alarms (indications of specific network events that are configured for the
hub from network management— also called SNMP event alarms). The start
of the table is shown below. Up to ten network management stations can be
entered into the table. Entry 0 (zero) is used for the “all managers allowed”
entry.
ID Manager Address (IP or IPX) Receive Alarms?
0 All managers allowed NA
1
2
The hub is initially shipped with all network management stations allowed
to manage the hub, but the “all managers” entry does not identify where
alarms are to be sent. Specific addresses must be entered into the table to
identify where the alarms should be sent.
Note If you want to restrict which management stations are allowed to
manage the hub, delete entry 0. Then add the allowed management
stations with the A command.
At the interface prompt, enter MA; the current authorized managers list is
displayed and you are prompted to add or delete an entry in the list, or to
enter E to end your editing.
To add an entry, enter A at the prompt. Enter the IP or IPX address of the
network management station, or enter A to allow all managers to manage
the hub, then indicate at the next prompt whether this management station
should receive alarms generated by the hub. A new entry is added to the list.
Extended Hub
Capabilities
Extended Hub Capabilities
2-18