Ethernet SNMP Module Installation and Reference Guide ( J2603B) 1995-10

Features
If the optional HP Ethernet SNMP Module is installed in your hub, the hub
functionality is enhanced with these additional features:
Advanced embedded SNMP agent code enabling the hub to be
managed remotely from a network management station that
supports Simple Network Management Protocol (SNMP) over IP
(using the configured IP address) or Novell NetWare (IPX). The
agent code also provides HP EASE (Embedded Advanced Sampling
Environment), which samples network data for enhanced
diagnostics from a network management station.
Extended hub management capabilities, described later in this
document in chapter 2, “Extended Hub Capabilities”.
Enhanced out-of-band management access including:
• support for higher baud rates beyond the default 9600 baud on
the hub’s out-of-band management RS-232 port, and automatic
sensing of the selected baud rate when connecting with the hub,
• full V.22bis modem line control for remote out-of-band
management access to the hub or stack of hubs.
Updatable firmware that enables enhancements to be downloaded
either from a computer attached to the out-of-band management
port or over the network.
Advanced integrated design including an Intel i960 RISC
processor, 1 megabyte RAM, 8 kilobytes EEPROM for configuration
data, and 256 kilobytes flash EEPROM for additional processing
power and future upgrade capabilities.
Support for extended network functionality through add-on
auxiliary modules. The SNMP Module has a connector onto which
you can attach an auxiliary module, for example the HP J2623A and
HP J2624A Dial-A-LAN or HP J2628A Router 210 modules. You then
install the combined module assembly in the HP AdvanceStack
10Base-T hub.
Contact your HP-authorized LAN dealer or HP sales representative
for information on available auxiliary modules.
iv