Installation and Reference Guide (J3210A, J3212A, J3200A, J3202A, J3204A) 1996-08

1-6
Installing the Management Module
Removing the Module
Installing the Management
Module
Removing the Module
The module is removed from the hub by reversing the installation steps
described earlier in this document. To remove the module, follow these steps:
1. Remove power from the hub by unplugging the power cord.
2. Remove the Extender Cable(s).
3. Unscrew the two captured screws holding the module.
4. Pull the module out of the slot.
5. Replace the slot with the Management Slot cover plate and reinstall the
Extender Cable(s). You are finished when your hubs appear like this
illustration:
Warning Replace the cover plate over the slot using the two screws that hold it in place.
Be careful not to overtighten the screws. When using the hub, the cover plate
must always be installed. This is required not only for safety, but also to ensure
proper hub cooling.
Cover plate