Installation and Reference Guide (J3210A, J3212A, J3200A, J3202A, J3204A) 1996-08

3-4

Configuring the Switching Hubs in Software

Connecting to the ASCII Console

Configuring the Switching

Hubs in Software

Remotely, Using Telnet

The Management Module support a Telnet console session. Your Telnet

syntax depends on your TCP/IP software or your terminal server. By default,

Telnet is enabled. You can disable Telnet by using the “Connection Configu-

ration” screen in the ASCII console.

To establish a Telnet session, follow these steps:

1. Verify that the stack you are accessing has an HP Management Module

installed, that it has been configured with an IP address, and that it is

accessible from your PC or workstation.

2. In Windows NT or HP AdvanceStack Assistant, run the Telnet application

and select Remote System from the Connect menu and type the IP

address of the hub. For example:

telnet 192.1.1.1

telnet your_hub

(Your Telnet syntax depends on your TCP/IP software or your terminal

server. You can use a system name if you have name resolution such as

DNS.)

3. To end the Telnet session, select Logout from the main menu. Or use your

Telnet application’s command to close or quit the Telnet session.