Installation Guide (J3192C, and J3193B) 1998-07

15
1. In the switch console, use the Version command to determine which
version of the switch’s operating system (OS) software is in use. (At
the Main Menu, select Advanced Commands, then type version
and press [Enter].) (Use the exit command to return to the Main Menu.)
2. Determine whether to update the switch’s operating system (OS)
software to the OS version on the 3-1/2 inch Update Disk included with
the transceiver:
To Update the Switch 208/224 OS:
Use the software that is provided on the disk shipped with your HP J3192C
or HP J3193B transceiver.
The disk contains several files, including the following:
■ The following OS file:
filename.swi
where filename indicates the OS version number; for example:
A_01_24.swi OS for the Switch 208T and the Switch 224T
(with the J3178A management module
installed).
■ Other files not needed for the Switch 208T or Switch 224T.
Minimum OS Version Required*
Transceiver Model Switch 208T**
Switch 224T**
HP J3192A (UTP) Transceiver
Not Supported
HP J3192B (UTP) Transceiver A.01.01
HP J3192C (UTP) Transceiver A.01.20
HP J3193B (Fiber) Transceiver A.01.01
*To identify the OS version on your switch: Run the switch console
interface, select “Status and Counters” from the Main menu, and then
select “Switch Information” from the Status and Counters menu.
**The Switch 208/224 OS upgrade requires prior installation of the
optional Switch 208/224 Management Module in the Switch 208T or
224T. If Management Module is not installed, the transceiver operates
in the default 100Mbps, half-duplex mode only.
L&h_c_2.fm5 Page 15 Wednesday, July 15, 1998 12:22 PM