Installation Guide (J3192C, and J3193B) 1998-07

5
Insert the Transceiver Into the Slot
The transceivers are installed into an HP networking device, as follows:
1. Unplug the HP networking device from the AC power source. Then,
using a flat-bladed or Torx T-10 screwdriver, unscrew the two retaining
screws on the existing transceiver or 100Base-T transceiver cover
plate, and remove it from the HP networking device or device module.
2. While touching a metal part of the networking device to discharge any
static electricity difference between your body and the device, care-
fully remove the transceiver from its protective anti-static packaging.
Hold the transceiver by its edges, taking care not to touch any of its
metal connectors.
3. Slide the transceiver firmly into the 100Base-T transceiver slot as far
as it will go. The transceiver’s faceplate should touch the face of the
device. The following illustration shows twisted-pair and fiber-optic
transceivers sliding into an HP J3191A AdvanceStack Switch 100Base-
T Module.
4. Using the flat-bladed or Torx T-10 screwdriver, tighten the retaining
screws on the transceiver until they are snug. Be careful that you do
not overtighten the screws. Then, insert the hub or switch module into
the networking device.
Loosen these screws
L&h_c_2.fm5 Page 5 Wednesday, July 15, 1998 12:22 PM