Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide

D-2 Product Specifications

Hub Stack Expansion Up to 5 modules (60 ports)

Expansion Interface Stacking Cable

Configuration Automatic hub-ID and bus termination

Isolation Supports hub isolation from the stack

Switching Port Access Method CSMA/CD, 100 Mbit/s

Standards Conformance IEEE 802.3u 100Base-TX, FX

Communication Rate 10/100Base-TX, 10 or 100 Mbit/s (via auto-

sensing): 100Base-FX, 100 Mbit/s only

Communication Mode Full or half duplex for 10/100Base-TX (via auto-

negotiation), 100Base-FX (via manual

configuration)

Media Supported 100Base-TX 100Wtwisted-pair (2-pair);

Cat 5 for 100 Mbit/s,

or Cat 3,4,5 for 10 Mbit/s

100Base-FX 50/125 mm or 62.5/125

multimode fiber

Number of Ports 2 100Base-TX RJ-45 ports (1 MDI, 1 MDI-X), or

1 100Base-FX SC-type port

Indicator Panel Comprehensive array of LEDs for displaying

port link, collision, traffic, transmission speed,

transmission mode

Switching Criteria -

Network Bridging Function

filtering, forwarding and learning

Switching Method adaptive cut-through: cut-through, fragment-free

cut-through, and store-and-forward

Maximum Filtering Rate line speed

Maximum Forwarding Rate line speed

Network Latency less than 20 microseconds

Address Table 4K entries/port

Queue Buffer 160K bytes