Installation Guide (J3191A, J3192A, and J3193A) 1996-09

9
Installing the 100Base-T Module in an Unused Slot
6. Seat the module in the slot by simultaneously pushing up on both
extractor handles until they are firmly seated against the front panel of
the module (in the closed position). You should be able to see the module
pull into the slot when you raise the handles.
Figure 4. Extractor Handles in the Closed Position
If the switch has power during module installation, the LEDs will behave
as described in the “Slot and Port LED Behavior” table on the next page.
(If you have not already done so, install the LED label strip as described
in step 1 on page 7.)
Figure 5. Self-Test and Fault LEDs
7. Tighten the captured screw in each handle by using a flat-blade or
Torx T-10 screwdriver. Do not overtighten the screws.
Extractor Handles in the “Closed” Position
Self-test
Slot Fault