Installation Guide (J3191A, J3192A, and J3193A) 1996-09

11
Installing the 100Base-T Module in an Unused Slot
Figure 6. Securing the Module in the Slot
8. Connect the appropriate network cables to the module’s
100Base-T ports. See the transceiver manual for a description of the
supported cable type.
Figure 7. Connecting a Cable
Connection Type for a Fiber Connection Maximum Distance
Switch to switch, full duplex 2 km
Switch to switch, half duplex 412 meters
Switch to end node, full duplex 2 km
Switch to end node, half duplex 412 meters
Switch to Class I hub with 100 meters between the hub and end node 160 meters
Switch to Class II hub with 100 meters between the hub and end node 208 meters
Tighten These Two Screws
Fiber-optic cable. The maximum
distance depends on the device
connected to this port.
See the table below.
Category 5 cable.
Maximum: 100 meters
Hub to hub: crossover cable
Switch to switch: crossover
Switch to end node: straight-through