Installation Guide (J3191A, J3192A, and J3193A) 1996-09

iv
HP AdvanceStack Switch 100Base-T Module
■ You can exchange, or remove either the module itself or a transceiver in
the module. (Note that transceivers are to be installed in a module that is
removed from the Switch 2000.)
■ Because the 100Base-T Module is a “low power” module, you can install
up to six 100Base-T Modules in your Switch 2000, enabling you to “fully
load” the switch with up to 12 ports.
Software Prerequisite: To use the 100Base-T Switch Module in the Switch
2000, the switch must be running software version A.02.50 or later. (Refer to
step 1 under “Downloading Software” on page 2.)
Standards Adherence: The HP J3191A 100Base-T Switch Module complies
with the IEEE 802.3u standard.