Installation Guide (J3191A, J3192A, and J3193A) 1996-09

Installation

You can install a 100Base-T Module into any of the Switch 2000’s six module

slots. The following steps provide an overview. The actual installation

procedure begins on page 2.

1. Determine whether your Switch 2000 is running the necessary operating

system (OS) version and, if necessary, download a new version (page 2).

2. Install one or two 100Base-T transceivers into the 100Base-T module

(page 6).

3. Install the 100Base-T Module in a Switch 2000 slot (page 7).

4. (Optional) Customize the configuration for the module’s ports (page 12).

5. Reboot the switch (page 13).

If necessary, you can “hot-swap” one 100Base-T module for another; that is,

replace one module with another of the same type without rebooting the

switch (page 14). However, if you replace one module type with a different

module type (such as replacing an Ethernet Module with a 100Base-T Module),

you must reboot the Switch 2000 after making the replacement.

Included Parts

Each HP 100Base-T Module has the following components shipped with it:

■ HP AdvanceStack 100Base-T Module Installation and Reference Guide-

this manual (J3191-90001)

■ Warranty booklet

■ Module Label envelope with the 100Base-T Module label

■ Connectivity Card

■ Switch software disk