Switch 7700 Command reference Guide, v2.0

104 CHAPTER 5: USING ROUTING PROTOCOL COMMANDS
■ summary automatic
■ timer
IP Routing Policy Commands
■ apply as-path
■ apply community
■ apply cost
■ apply cost-type
■ apply ip next-hop
■ apply local-preference
■ apply origin
■ apply tag
■ display ip ip-prefix
■ display route-policy
■ filter-policy export
■ filter-policy import
■ if-match { acl | ip-prefix }
■ if-match as-path
■ if-match community
■ if-match cost
■ if-match interface
■ if-match ip next-hop
■ if-match tag
■ ip ip-prefix
■ route-policy
Route Capacity Configuration Commands
■ display memory limit
■ memory auto-establish disable
■ memory auto-establish enable
■ memory { safety | limit }
Routing Table Display
Commands
This section describes the commands you can use to display routing table
information.
When the Switch 7700 runs a routing protocol, it is able to perform the functions
of a router. The term router in this section can refer either to a physical router, or
to the Switch 7700 running a routing protocol.
display ip routing-table Syntax
display ip routing-table