Switch 7700 Command reference Guide, v2.0

110 CHAPTER 5: USING ROUTING PROTOCOL COMMANDS
To display the information on the active and inactive routes for prefix list abc2,
enter the following:
<SW7700>display ip routing-table ip-prefix abc2 verbose
The information displays in the following format:
Routes matched by ip-prefix abc2:
Generate Default: no
+ = Active Route, - = Last Active, # = Both* = Next hop in use
Summary count:4
**Destination: 127.0.0.0 Mask: 255.0.0.0
Protocol: #Direct Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Multicast Unicast>
Age: 3:47 Metric: 0/0
**Destination: 127.0.0.1 Mask: 255. 255. 255. 255
Protocol: #Direct Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
Vlinkindex: 0
State: <NotInstall NoAdvise Int ActiveU Retain Gateway Multicast
Unicast>
Age: 3:47Metric: 0/0
**Destination: 179.0.0.0 Mask: 255.0.0.0
Protocol: #Static Preference:-60
*NextHop: 4.1.1.1
Vlinkindex: 0
State: <Int Hidden Static Unicast>
Age: 3:47 Metric: 0/0
**Destination: 169.0.0.0 Mask: 255.0.0.0
Protocol: #Static Preference: 60
*NextHop: 2.1.1.1 Interface: 2.1.1.1(LoopBack1)
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
Age: 3:47 Metric: 0/0
**Destination: 169.0.0.0 Mask: 255.254.0.0
Protocol: #Static Preference: 60
*NextHop: 2.1.1.1 Interface: 2.1.1.1(LoopBack1)
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
Age: 3:47 Metric: 0/0
display ip routing-table
protocol
Syntax
display ip routing-table protocol protocol [ inactive | verbose ]
View
All views
Parameter
protocol Enter one of the following:
■ direct: Displays the direct connection route information
■ static: Displays the static route information.