Switch 7700 Command reference Guide, v2.0

RIP Configuration Commands 117
Description
Using the default cost command, you can set the default routing cost of an
imported route.
Using the undo default cost command, you can restore the default value.
If you do not specify a routing cost when using the import-route command, the
default cost you specify here is used.
Related command: import-route.
Example
To set the default routing cost of the imported route of another routing protocol
to 3, enter the following:
[SW7700-rip]default cost 3
display rip Syntax
display rip
View
All views
Parameter
None
Description
Using the display rip command, you can view the current RIP running state and
its configuration information.
Example
To display the current running state and configuration information of the RIP, enter
the following:
<SW7700>display rip
The information displays in the following format:
RIP is turned on
public net VPN-Instance
Checkzero is on Default cost : 1
Summary is on Preference : 100
No peer router
Network :
202.38.168.0
The information shown above indicates that RIP is running, the default-metric is 1,
no unicast address is specified, the interface of the network segment
202.38.168.0 is enabled and the RIP preference is 100.
filter-policy export Syntax
filter-policy { acl_number | ip-prefix ip_prefix_name } export [
routing_protocol ]