Switch 7700 Command reference Guide, v2.0

RIP Configuration Commands 123
Description
Use the reset command to reset the system configuration parameters of RIP.
When you need to re-configure parameters of RIP, this command can be used to
restore to the default setting.
Example
Reset the RIP system.
[SW7700-rip]reset
rip Syntax
rip
undo rip
View
System view
Parameter
None
Description
Using the rip command, you can enable RIP and enter the RIP command view.
From here, you can configure RIP using the other commands described in this
section.
Using the undo rip command, you can disable RIP. By default, RIP is disabled.
Enabling RIP does not affect interface configurations.
Example
To enable RIP, and enter RIP view, enter the following:
[SW7700]rip
[SW7700-rip]
rip authentication-mode Syntax
rip authentication-mode simple password
rip authentication-mode md5 key-string string
rip authentication-mode md5 key-id id
rip authentication-mode md5 type { nonstandard | usual }
undo rip authentication-mode
View
VLAN interface view
Parameter
simple: Enter to specify simple text authentication mode.
password: Enter the simple text authentication key.
md5: Enter to specify MD5 cipher text authentication mode.