Switch 7700 Command reference Guide, v2.0

RIP Configuration Commands 129
Parameter
None
Description
Using the rip work command, you can enable the running of RIP on an interface.
This is the default.
Using the undo rip work command, you can disable the running of RIP on an
interface.
This command is used in conjunction with the rip input, rip output and
network commands. Refer to the descriptions of these commands for details.
Related commands: network, rip input, rip output.
Example
To disable the running of RIP on interface Vlan-interface 1, enter the following:
[SW7700]interface Vlan-interface 1
[SW7700-Vlan-interface1]undo rip work
summary Syntax
summary
undo summary
View
RIP view
Parameter
None
Description
Using the summary command, you can activate RIP-2 automatic route
summarization. This is the default.
Using the undo summary command, you can disable RIP-2 automatic route
summarization.
Route aggregation can be performed to reduce the routing traffic on the network
as well as to reduce the size of the routing table. RIP-1 does not support subnet
mask. Forwarding subnet route may cause ambiguity. Therefore, RIP-1 uses route
summarization all the time. If RIP-2 is used, route summarization function can be
disabled with the
undo summary command, when it is necessary to broadcast the
subnet route.
Related command: rip