Switch 7700 Command reference Guide, v2.0

Integrated IS-IS Configuration Commands 163
Parameter
route-policy route_policy_name: Only the route that satisfies the matching
requirement of specified Route-policy can generate default route.
Description
■ Use the default-route-advertise command to create the default route of
L1, L2 router.
■ Use the undo default-route-advertise command to cancel this
configuration.
By default, L2 router creates the default route.
This command can be set on L1 router or L2 router. By default, the route is
generated on L2 TCP. If level level-1 is set in Route-policy view, the default route
will be generated on L1 LSP. If level level-2 is set in Route-policy view, the default
route will be generated on L2 LSP. If level level-1-2 is set in Route-policy view, the
default route will be generated on both L1 LSP and L2 LSP.
Example
Set the router to create the default route in the LSP of correspond level.
[SW7700]default-route-advertise
display isis interface Syntax
display isis interface [ verbose ]
View
All views
Parameter
verbose: If this parameter is used, the details of the interface will be displayed.
Description
Use the display isis interface command to view the information of the
enabled IS-IS interface.
This command displays the information of the enabled IS-IS interface, including
interface name, IP address of the interface, link state of the interface and so on.
Besides displaying all the information shown by the
display isis interface
command, the
display isis interface verbose command displays such
information about the IS-IS parameters of the interface as CSNP packet broadcast
interval, Hello packet broadcast interval and invalid number of Hello packet.
Example
Display the information about the enabled IS-IS interface.
<SW7700>display isis interface
Interface IP Address Id Link.Sta IP.Sta MTU Type DR
Vlan-interface3 2.1.1.12 001 Up Up 1497 L12 No/No
Display the details of the IS-IS enabled interface.
<SW7700>display isis interface verbose