Switch 7700 Command reference Guide, v2.0

IP Routing Policy Configuration Commands 227
Example
Configure the Keep-alive timer as 30 seconds and Hold-time timer as 90 seconds.
[SW7700-bgp]timer keep-alive 30 hold 90
IP Routing Policy
Configuration
Commands
This section describes the commands you can use to configure IP Routing Policy.
These commands operate across all routing protocols.
When the Switch 7700 runs a routing protocol, it is able to perform the functions
of a router. The term router in this section can refer either to a physical router or to
the Switch 7700 running a routing protocol.
apply as-path Syntax
apply as-path as_number_1 [ as_number_2 [ as_number_3 ... ] ]
undo apply as-path
View
Route policy view
Parameter
as_number_1... as_number_n: AS number to be added.
Description
■ Use the apply as-path command to configure AS number to be added in
front of the original AS path in Route-policy.
■ Use the undo apply as-path command to cancel the AS sequence number
added in front of the original AS path.
By default, no AS number is set.
If the match condition of Route-policy is matched, the AS attribute of the
transmitting route will be changed.
Example
[SW7700-route-policy]apply as-path 200
apply community Syntax
apply community { { { aa:nn | no-export-sunconfed | no-export |
no-advertise} … [ additive ] } | additive | none }
undo apply community
View
Route policy view
Parameter
aa:nn: Community number.