Switch 7700 Command reference Guide, v2.0

230 CHAPTER 5: USING ROUTING PROTOCOL COMMANDS
By default, no apply sub-statement is defined.
When it is used for setting route information attribute, it sets the next hop address
area of route information passing filtration.
Related command: if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply
local-preference
, apply cost, apply origin and apply tag.
Example
Set the next hop address of route information as 193.1.1.8 when it is used for
setting route information attribute.
[SW7700-route-policy]apply ip next-hop 193.1.1.8
apply isis Syntax
apply isis [ level-1 | level-2 | level-1-2 ]
undo apply isis
View
Route policy view
Parameter
level-1: Set to import the matched route to level-1 area.
level-2: Set to import the matched route to level-2 area.
level-1-2: Set to import the matched route to both level-1 and levle-2 area.
Description
■ Use the apply isis command to configure to apply the level of a matched
route to be imported to level-1, level-2 or level-1-2.
■ Use the undo apply isis command to cancel the apply sub-statement.
By default, no apply clause is defined.
For the related commands: if-match interface, if-match acl, if-match
ip-prefix
, if-match ip next-hop, if-match cost, if-match tag,
route-policy, apply ip next-hop, apply cost, apply origin, apply tag.
Example
Define a set clause, setting to import the route to level-2.
[SW7700-route-policy]apply isis level-2
apply local-preference Syntax
apply local-preference local_preference
undo apply local-preference