Switch 7700 Command reference Guide, v2.0

Route Capacity Configuration Commands 243
memory auto-establish
disable
Syntax
memory auto-establish disable
View
System view
Parameter
None
Description
Use the memory auto-establish disable command to disable the routing
protocol connection that is forcibly disconnected to recover automatically when
the idle memory of the Ethernet switch reaches this value. Thus, connections of all
the routing protocols will not recover when the idle memory of the Ethernet
switch recovers to a safety value. In this case, you need to restart the routing
protocol to recover the connections.
By default, when the idle memory of the Ethernet switch recovers to a safety
value, connections of all the routing protocols will always recover (when the idle
memory of the Ethernet switch reduces to a lower limit, the connection will be
disconnected forcibly).
You shall use the command cautiously.
Related commands: memory auto-establish enable, memory { safety |
limit }
, display memory limit.
Example
Disable memory resume of the current Ethernet switch and recover connections of
all the protocols automatically.
[SW7700]memory auto-establish disable
[SW7700]
%4/10/2003 17:45:44-RM-5-S1-RTLOG:You have changed the model of
connection
memory auto-establish
enable
Syntax
memory auto-establish enable
View
System view
The times of disconnect: 0 The times of the connection disconnecting of the Ethernet
switch is 0.
The times of reconnect: 0 The times of the connection reestablishment of the Ethernet
switch is 0.
The current state: Normal The current state is normal. (If entering the emergent state, the
system will display "Exigence" )
Table 17 The description for the information displayed by the display memory limit
command